Remove the top part [C] x1. Then push down to lock the tabs on the front and rear end of the PCU. Tap 2 or 3 times at each location, to make the toner fall into the development section. Remove the rear cover [B] x3, Coupling x1. Network Connectivity – Have a MFC that’s lost it’s ability to communicate with the network after about 4 years.

Uploader: Bajinn
Date Added: 16 December 2010
File Size: 18.17 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 17569
Price: Free* [*Free Regsitration Required]

Separate the top [E] and bottom [F] of the development unit. Continue to rotate the black gear until the developer is level. Make sure that the holes for the screws on the front and rear end of the PCU are aligned correctly. The drum unit is photo conductive. Details lahier Mods by vBSocial. Tighten the three screws and coupling [D].

To prevent toner leakage, never loosen kanier remove the screws shown in the illustration below. Results 1 to 1 of 1. Install the PCU in the machine. Lightly tap the top of the PCU [A] with a screwdriver at 8 locations. Remove the rear shoulder screw [B] x1.

  IBM V7000 SUBSYSTEM DEVICE DRIVER

Printer: Lanier MP /LD | OpenPrinting – The Linux Foundation

Remove some toner from the edge of the old blade with your finger, and apply it evenly along the full length of the new blade. RJ45 port has a steady yellow light but an additional green light will momentarily wink on when cold booting the machine.

Release the front tab [C]. Photoconductor Unit PCU 1. While continuing to turn the black gear, slowly move the pack left and right m pour the remaining half of the developer over the augur until the developer is level. Another guy posted to change the wireless Separate the top and bottom parts of the PCU. Tighten the top screw [F]. Assemble the PCU and install it in the machine.

D0193501 Ricoh Aficio MP 2550 Toner Supply Unit

Release the front and rear springs [C]. Leave a Reply Cancel reply You must be logged in to post a comment. Remove the rear cover [B] x3, Coupling x1. Open and close the door two more times. Get the Android App.

  INSTALLABLE ISAM DRIVER DOWNLOAD

While turning the black gear [K], slowly move the pack left and right and pour half of the developer over the auger [L]. Make 5 sample copies.

Lanier MP 2550/LD425 PCL Drivers

Remove the front cover [A] x2. These locations must be at equal intervals. Replace the cleaning blade [A] x2 Laniier See Note in Bold Green above. Network Connectivity – Have a MFC that’s lost it’s ability to communicate with the network after about 4 years.

Follow the cautions below when handling a PCU. Bookmarks Bookmarks Digg del. I’m trying to verify if this is a software or hardware problem.

Make sure that the head of the stud is put in the correct position.